It's been a long week but the engine is alive.

Short Video here.

https://youtu.be/nwWJmaraJdI

Been awhile since I have posted.

Here’s my HX 1 Tonner build.

Stroked 355 using the 808 Delco
T5 manual
VN Borgwarner diff
The complete build is on Facebook.

https://www.facebook.com/hxbuild/

It’s coming along slowly.

Been awhile since I posted, here is an updated picture of the SS
Been pretty busy on the HX 1 ton ute
Progress can been seen by going to this link.

https://m.facebook.com/hxbuild/

The ute is coming along, a long way to go.

Replaced TPS and IAC and it's all good, re did the timing seems to be going good again.

Had no problems fitting the bar and sits close to factory, there was some minor marks/scratches on the bar from transit but that was it.

There are two plastic clips on the steel bar that holds the front bumper on each side. (they clip/push into position) http://www.rsp.net.au/Images/Products/Thumbnails/92043558.jpg Screws on the top of the front of bumper and the ones in the wheel arch. Also the two bars on the bottom of the bar. Tha...

Yeah no speed sensor due to been converted from an auto. I do have a speedometer signal interface http://www.dakotadigital.com/index.cfm/page/ptype=product/product_id=126/category_id=287/home_id=59/mode=prod/prd126.htm but i have not got it to work 100% yet. If any one knows how I should have it set...

Here is a longer log.

.

Been working on the ute cutting out the rust and replacing with steel so here's some sneak peaks.
Still needs a lot of work but it's coming along