Thank you very very much!

to pman92. Thanks for the answer. I compared the file OSE $12P V111 BLCF V8 __manfuel mod.bin (which is laid out VL400) with the original OSE $12P V111 BLCF V8.bin. The difference between them was at this address 0x1BB8. But I decided to ask knowledgeable people not to spoil anything. Am I on the ri...

up

Excuse me...
If I understood correctly:
in firmware 12Pv111.bin at address 0x1BB8 I need to change the value from 0x0084 to 0x0153 to get the stream "manifold fuel", and in 1bar ADX instead of "CTS Voltage" the value "manifold fuel" will be shown.
???

This is a standard ECU and wiring Opel Astra (European counterpart Holden Astra 1600 TBI, ECU 808). Just added MAT-sensor, bin is a $12P 111. Ignition of the ECU is not in use, working stock (sensor - commutator -distributor). COMs board like this: http://pcmhacking.net/forums/viewtopic.php?f=11&...

yoda69,antus thanks for answers

But how then to explain the jumps KpH (purple line)?

Generally, it is necessary to check all - wiring, ECU, sensors...

Please help determine fault.
On the log it looks like this: There are sharp jumps in RPM, KPH, VE.
It is sometimes strong stumbles occur, and sometimes not.
Is this a problem in hardware or software?
Where to look and what to check?

to Grim304.
Thanks for the advice.
I'm not going to buy eBay NVRAM.
I was going to make NVRAM myself.
But a little knowledge and information.

At the moment I still do not understand how to give a signal WE

Holden202T wrote:what do you need explained ?

Can I put DS1230 on a memcal?
And were is '808 write pin?

Is it shown correctly?

http://pcmhacking.net/forums/viewtopic.php?f=33&t=4111
http://pcmhacking.net/forums/viewtopic. ... PNG#p63662

Explain to me somebody - Grim304's device works?