http://www.ebay.com.au/itm/VOLVO-GREEN- ... 83e&_uhb=1
Anyone come across these?
Seem well priced for the flow. I havent checked the impedence yet. I would want them reconditioned and dead times measured first do The1 would be the man for that! Look like a good cheap upgrade for my mates car.
Ive already set the reg to 45 psi (fixed) would going higher affect the opening times?
Car has upgraded lines Walbro intank pump and adjustable reg with standard rails.
Injector duty cycle
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Injector duty cycle
like you say assuming they are the right impedence then they should be right.... I'd say they will be.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Injector duty cycle
mates car is only a 4cyl? Yes pressure will change deadtimes a bit and usually flow rate to. All depends on the injector design
Re: Injector duty cycle
Its a Holden V8 stroker 355 running Bosch 775 blue tops
Re: Injector duty cycle
chuck a set of 36lb ones in, there $199 flow matched. Could turn them down to 43psi which would drop them to 32lb or so. Or just run at 51psi if it's a MAF model you can play with the EOI delay to get some nice mix higher up.
Re: Injector duty cycle
Thanks mate, you're saying you could sell me a set of 8 36lp for $200?
It's running 12P with BPC of .13 peak VE is at 95%
They are rated at 51psi is that what pressure the super 6 ran at?
It's running 12P with BPC of .13 peak VE is at 95%
They are rated at 51psi is that what pressure the super 6 ran at?
Re: Injector duty cycle
yes they run 51psi or 3.5bar from factory. Yep flow matched sets on my ebay. though there sets of 6, i could do a set of 8 for a little more if your keen.
Re: Injector duty cycle
Thanks if we go a new set thats what we will do. Thanks
Is that price reconditioned?
Is that price reconditioned?
Re: Injector duty cycle
same as listing, full serviced and flow tested, flow matched set <2% prob around $250 delivered. anything further pm me, thread dig lol