Couldn't find help and not sure whether this is the appropriate section to post.
Where can I find the definition file for Holden Commodore VX2 to use with EFILIVE.
I got it up and running but not sure whether I am reading the right fault codes.
Following error codes show up
13 o2 missing
14 ect volts low
15 ect volts high
16 ect volts unstable
17 ect circuit
19 tps stuck
21 tps volts high
22 tps volts low
Holden Vx2 Select Vehicle File in EFILIVE
-
- Posts: 1
- Joined: Thu Jul 10, 2014 4:30 pm
- cars: VX2 Commodore
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Holden Vx2 Select Vehicle File in EFILIVE
I'd say your best bet would be the efilive support forums etc ....
the stuff we do here is not really related to efilive or other commercial products, its more for the diy'er wanting to use programs like Tunerpro and tune / log with that.
also when posting something like this you should try and put more information in .... is it a v6/v8, auto/manual, has something been changed to cause all these error codes ?
the stuff we do here is not really related to efilive or other commercial products, its more for the diy'er wanting to use programs like Tunerpro and tune / log with that.
also when posting something like this you should try and put more information in .... is it a v6/v8, auto/manual, has something been changed to cause all these error codes ?
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread