Rang marks, The sim just needs key on power, earth and the signal wire to the pcm.
Haven't got an aldl cable but are they hard to make? And also where would I plug it into as I don't have a diagnostic port, just engine harness, pcm and simulator.
and the pcm is fine. I have a standard vs v6 as well and plugged it into that and it ran fine.
Vs v6 ecotec not starting
- antus
- Site Admin
- Posts: 8250
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: Vs v6 ecotec not starting
Check the wiring diagram for your pcm and find aldl data or serial data (terminology depends what diagram you have.) In its simplest form an Aldl circuit can be made with a usb to ttl serial interface and a diode and a resistor. The catch is the chip must be capable of 8192 baud which usually means ftdi brand and there are clones on ebay which dont work. If your keen to try search the subject and you will find. Alternatively there are pre-made ones with more filtering for reliability in the for sale area.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
Re: Vs v6 ecotec not starting
Failing getting it to go will a VP/VR harness and computer run the ecotec motor?
Just that the older setup is alot more basic, no vats, electronic auto box wiring
I realize that the older setup is batch injection, but if it's gonna make it way easier, will it work?
Just that the older setup is alot more basic, no vats, electronic auto box wiring
I realize that the older setup is batch injection, but if it's gonna make it way easier, will it work?
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Vs v6 ecotec not starting
sure does work, theres even a $12P ecotec map based tune in the custom tunes section.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread