HI all, I have an Innovate wide band o2 sensor and associated electronics which I want to use to attempt some tuning on my l67. My question is, can I temporarily remove one the l67s o2 senors and screw the innovate in? Do I need to weld a new nut on the exhaust somewhere so I can add the extra o2 sensor??
Ev.
Innovate Lamda meter
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Innovate Lamda meter
either way will work, just a matter of which you prefer and which is easier
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Innovate Lamda meter
Ok cool, so its ok to just disconnect one of the factory sensors while logging? That doesn't screw up what the PCM is doing with regards to fuel delivery?
Re: Innovate Lamda meter
if you look in whatever xdf your using there should be a flag you can untick, which will put the ecu into single o2 mode, you can then use the passengers side o2 bung and ecu will only use drivers side for closed loop.