Hi Guy's,
I am new to this and am having issues getting the wideband to display in TunerPro.
I have a VR V8 Auto with the NVRam installed. I can connect, emulate and make changes to settings.
I have an Innovate LC2 wideband O2 sensor and controller. This has been set up to deliver 0-5V. This has been measured and that is what the unit is outputting. I have connected the wideband to pin D8.
I am using the following file/tune.
Bin - BMZC_mod_wideband
XDF - $11B_V105
ADX - VR_$11_v1.05-tp5
I did watch one of the videos on the site and it showed the ADX editor and the packet offset as 0x30. The VR_$11_v1.05-tp5 has the offset as 0x00.
I am not sure where to look next. Any suggestions would be great.
Wideband VR V8
-
- Posts: 2
- Joined: Thu Mar 20, 2014 4:51 pm
- cars: Holden FJ with VR 5.0
Re: Wideband VR V8
with your pcm, you may as well use the 11P collection. all the matching bin, xdf, adx files are there, with more features and wideband logging working.
http://pcmhacking.net/forums/viewtopic.php?f=27&t=3798
http://pcmhacking.net/forums/viewtopic.php?f=27&t=3798
Re: Wideband VR V8
Could you convert to $11P code?
-
- Posts: 2
- Joined: Thu Mar 20, 2014 4:51 pm
- cars: Holden FJ with VR 5.0
Re: Wideband VR V8
Hi Guys,
The 11p has made all the difference. It is showing the wideband and all seems to be working great.
The learning curve is steep. The Ppwer/Econ stuff looks handy as well.
Thanks for you assistance.
The 11p has made all the difference. It is showing the wideband and all seems to be working great.
The learning curve is steep. The Ppwer/Econ stuff looks handy as well.
Thanks for you assistance.