Pull up resistor removal

Holden/Delco Tuning. ALDL, OBD 1.5. Circa 1989 to 2004.
Post Reply
jezza351
Posts: 116
Joined: Fri May 22, 2009 6:49 pm
cars: vr ss comodooree

Pull up resistor removal

Post by jezza351 »

Hi guys , probably a silly question but I'm at the stage of modding the pcm for real time with nvram and removing the 1k pull up resistor for the wideband, in instructions it says to just remove the resistor , do I also bridge the the spots on the board with solder to link them back up or just remove and leave the board as it is ?
Top
Dylan
Posts: 3356
Joined: Mon Aug 02, 2010 6:35 pm
cars: VR Commodore V8

Re: Pull up resistor removal

Post by Dylan »

Just remove it. Also note if you had any offsets in your cal they will need adjusting afterwards.
Top
jezza351
Posts: 116
Joined: Fri May 22, 2009 6:49 pm
cars: vr ss comodooree

Re: Pull up resistor removal

Post by jezza351 »

Dylan wrote:Just remove it. Also note if you had any offsets in your cal they will need adjusting afterwards.
cheers Dylan
Top
Post Reply

Return to “Holden ALDL ECUs”