ALDL LCD Display

[vp304]

Hey BennVenn can i flash this newer firmware on mine even tho im on a proto type board ?

[BennVenn]

Yeah I kept it all backwards compatible, just drop the firmware file on your SD and pop it in the display. When you power up it'll say ERASING, then UPDATING and you're done!

[vp304]

Done Thanks mate

[BennVenn]

Firmware V0.02 is out

Brightness Increase (previous update decreased max brightness)
160 Baud ALDL is now supported.

160ALDL notes: Bridge SJ1 on the back to Display 160ALDL Coolant temp and battery voltage. Bridge SJ1+SJ2 to display RAW ALDL - 20bytes. Use a 10k resistor on the diagnostic pin to enable low speed ALDL. Use a voltage divider (2 resistors) to drop the 12v ALDL voltage to 5volts or less. SD card not required in 160ALDL mode.

160ALDL Tested with N13 MEMCAL's - 1.6L/1.8L/Astra/Pulsar/Opel Corsa A/Vauxhall

ALDLCD_V002.rar

(11.09 KiB) Downloaded 228 times

[Holden202T]

looking good!

[vp304]

Holden202T great little bit of gear ive had mine from BennVenn running for over 6 months now.

[Holden202T]

i'd love you try one if you have any available ?

[vp304]

i'd love you try one if you have any available ?

I was thinking of getting another with a larger screen maybe also

[BennVenn]

Hey guys, it's been a minute! I've got 3 or 4 left here I can assemble if anyone wants one. I don't think I'll have a whole lot of time to put into the GUI side of things so it'll be just a text config for now. Happy to help set it up how you want it if the instructions don't make sense. I believe I linked my source here too if anyone wants to add or change the main code.

[Holden202T]

im keen, happy to have a DIY kit too to assemble myself if your ok with that!