pcmhacking.net

This is the interface I'd already have, that goes from laptop to aldl with tunerpro?

If so, what else for the bluetooth

That one isnt bluetooth, you use an USB OTG cable to plug it in, like (random pick, untested) https://www.ebay.com.au/itm/166207789629

G'day again,

Still trying hard with ALDLDroid on VY V6 (conversion, no BCM)
Can get ALDLDroid to connect to ECU no worries, using Envyous Customs cable connected to Pixel 6 phone.
Tried a few different ADX's now
No problem using same ADXs in TP5, then switch to ALDLdroid using same ADX (typically The1's enhanced) and can only get:
"Incorrect Response Length From ECU (2 vs 84)" etc... sometimes the numbers change..

Anyway, my question is - should I start looking at cable and device settings or playing with ADX in TP5?
I've tried echo on/off and with/without checksum validation in ALDLDroid.

Thanks again......

look at the adx. aldl droid isnt compatible with all adx. if you figure it out post here. maybe find a 12p one that works with aldldroid (I think one exists) and modify it bit by bit to make one compatible with aldl droid. get the length and header stuff right first so it communicates properly even if the data displays wrong, then try updating the1s to match, so you can figure out if its problems with the header or packet sizeings or payload.

thank Antus for the tip - will do some digging and learning!