Engine conversion. VY engine/gearbox and computer into WB
Re: Engine conversion. VY engine/gearbox and computer into W
The PCM seemed to be ok when connected to PC to turn off VATS. But then I don't know if that proves the PCM is ok
I was hoping it was just the air temp sensor (Missing)
I was hoping it was just the air temp sensor (Missing)
Re: Engine conversion. VY engine/gearbox and computer into W
Missing IAT wont stop it from starting or running, check your connection to the pcm.
According to chemistry, alcohol is a solution...
Re: Engine conversion. VY engine/gearbox and computer into W
ThanksBiggvl wrote:Missing IAT wont stop it from starting or running, check your connection to the pcm.
Will do
Re: Engine conversion. VY engine/gearbox and computer into W
Loom connector to PCM looks ok, pins look ok
I got efi live but I need a comms cable and adapter of some sort. Can anyone tell me what cable/adapter I need, I only have the software
I got efi live but I need a comms cable and adapter of some sort. Can anyone tell me what cable/adapter I need, I only have the software
Re: Engine conversion. VY engine/gearbox and computer into W
I should mention there is a flashing padlock shaped light near the gauges
Fuses look good
Maybe it is PCM
Fuses look good
Maybe it is PCM
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: Engine conversion. VY engine/gearbox and computer into W
do you have the key put it in the ignition and turn it till it contacts the metal ring surrounding the key thats probably the padlock symbol and the partial cranking.or remove the start relay and bridge the terminals with a bit of wire so it cranks it should run if vats etc is off properly.i just did this to a vx ls1 with an ecu borrowed from a vt with vats off to test an engine before ripping it out.the key was the wrong key and wouldnt crank but ran when we cranked it over manually via the relay
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: Engine conversion. VY engine/gearbox and computer into W
Yep, flashing padlock is the security system in the BCM is still armed due to no key being used.
With no comms the dash error is different to what you get with a faulty sensor, the no comms between modules is normally a service error message instead of an engine picture.
With no comms the dash error is different to what you get with a faulty sensor, the no comms between modules is normally a service error message instead of an engine picture.
Re: Engine conversion. VY engine/gearbox and computer into W
No I don't have the key and I pulled off the metal ring
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: Engine conversion. VY engine/gearbox and computer into W
just bridge pin 87 and 30 on the start relay with your ignition on see if it starts.if it does youre ready to cut the wiring down to the bare 4 wire or so hookup minus bcm and pim
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
Re: Engine conversion. VY engine/gearbox and computer into W
Just to be clear, link up 87 to 30 on ignition relay with bcm or with out bcm??
Thanks
Thanks