Tune / bin

There's no jumper selecting wether its using the memcal or the nvram board for cylinder selection use the one that's floating on the 6cylinder jumper and put it on jmp or mem if you have a v8 memcal Mate....you are a dead set legend......I will PM you and get a address so I can send you a bottle of...

And if you are reading 170-180kpa map you must be using the 2 bar adx not a 1 bar one mines shows around 80kpa struggling to idle and goes back to normal ish 50kpa with revs up s2nd me a copy of your tune cause the injector ms value and duty cycle don't really match up with each other its injecting...

delcowizzid wrote:The log shows a 4 cylinder memcal is on the header or the jumper is on 4 cylinder

weird! the Jumpers are correct, so must be the tune somehow, Ill download it directly from the ecu in the morning and upload.

Thanks a heap!

What about the MAP sensor and the vacuum line running to it? Maybe remove the hose and make sure its not plugged with moisture, particularly if its mounted lower than the vacuum tie in point. Also by igniter do you mean the coil or the ignition module? Thanks for the suggestion mate, if there was v...

I haven’t looked at the log, but if you heard a “pop” I’d be looking for a vacuum leak. Check all hoses are fine and not split/perished and connected correctly. When it’s running try and spray some wd40 or similar around intake manifold and hoses, listen for change of engine noise. Thanks for the s...

delcowizzid wrote:Pull the vacuum hose off the fuel pressure regulator and see if fuel comes out when you prime it

Thanks for the suggestion mate, just tried it, and its dry.

Hi Guys, I generally try and work things out myself, and cant really afford a mobile mechanic at the moment, so really hoping that some of you generous lads wouldnt mind helping me diagnose a problem im having with my 304. Im pretty much at wits end with the thing, so any help would be greatly appre...

Thank you very much guys! Ill keep plugging at it!

Just went for a drive with Dylans tune. Heres the initial start and warm up, along with the hunting idle at the end. Warmup-withidle-28-06-16.xdl I then did a 3rd gear WOT run. WOT In 3rd.xdl Seemed down on power compared to yesterday, but that might have been because it was smoother than my terribl...