Code structure is similar but not compatible , e55 os starts at 0x40000 on e77 it starts ox20000 Main problem would be that on vz the pim (immobilzer) communicates with pcm directly on hi speed canbus and on ve the immobilizer is on lo speed canbus and uses bcm as comms gateway to e77, A vz and ve i...

The only other place the security code is stored is in the PIM , after reseting pcm using the PCM security code , when you link PIM and PCM the security code used is the one on the PIM ,the PCM then learns the PIM security code, if you read PIM eeprom, security code is last 2 bytes and there byte sw...

I used ACDelcoDTS' online subscription (40 USD for 2 years, covering one VIN) and managed to program a fresh ACDelco-remanufactured e55. I had programmed them before with tis and had no problem as well , maybe most of there files are complete but some are missing cal segment Where do you have the O...

So far, it's worked fine programming other modules in the car, and gets about 75% before failing on these failed ECU. Using passthrough fails at about 20% - but again, they're suspect ECM. I had exactly the same problem recently programming e55 pcms . Programming routine should have been Erase all ...

If you think it was me that edited your details from your ls1 chksum plugin then your very mistaken All the ls1 xdf files I write do not need any external plugins , they use the default tunerpro chksum plugin to calculate all calibration modules checksums . I have never needed to use your plugin , e...

The 808 ecu supplies 12v to the fuel pump relay when engine is running or for a few seconds for priming when ign first turned on

Do you sell the dash guage as well ,never got one when I bought mine a few years ago , wish I did though so I can see AFR without laptop hooked up.

If you use a std vr auto/manual adx file with $12p not all data is correct , $12p uses slightly different aldl data format to std $12 code

If would try putting original injectors back in and see if problem still happens , was running fine before you changed them , maybe one has an intermittent fault when it gets hot.

For Y1 the top pcm uses lo profile crystal , the bottom pcm has a std profile crystal