Hi All,

I Hope everyone is staying safe!

I am having Trouble Identify this plug. It is a a 5 pin plug that’s was used by VDO in the 90s.
Any support would be appreciated!

Thanks Daniel

Hi Guys, I am putting a LSx into a VL and am just trying to get the tacho operational. I have managed to put Tacho into 4 Cylinder mode which is correct for a LSx however the VL utilises a coil signal and am trying to convert to a ECU signal. It utilises a SAK-215 Chip and uses two 33K resister on s...

antus wrote:I would say no. but incase someone else knows you should advise what cluster your talking about.

Good point VY / VZ Commodores.

Thanks

Dylan wrote:With the Flash Tool from here it's possible on an 8192 baud code.

Sorry should of mentioned its a cluster not a ecu.

Is it still possible? I can unlock it but just a pita to do table by table
thanks

Hi Guys,

I was wondering if anybody could point me in the right direction?

I am trying to download a full bin file via ALDL.

I am able to read each table individually but want to be able to read the whole bin.

Any help / direction will be appreciated.

Thanks
Daniel

OK, gotcha (the videos weren't showing on my tablet, only a still image). Well, I think there's about a 1 second delay in both videos (hard to judge exactly for the first video, since I can't be exactly sure where the threshold is, and I don't have a stopwatch handy). So that's just the way the fir...

vlad01 wrote:looking at it, i'd say its for fine calibration the main knob to its RPM scale facia plate.

Spot on mate....

Does this mean there is NO WAY to speed it up as 1.5K out is unusable. Hi Daniel, What exactly are you saying, that it's slow to respond, or that the threshold only goes up to 1500 RPM? Joe. Hi Joe, In the videos I have uploaded if you ease the gas pedal down slowly when it hits the desired RPM it ...

Thanks for all the input.

Ill have a play with the resistor values..... I assume the one circled in blue is the one in question.... it is 2W.

What does the pod circled in red do.... I cant figure it out appears to connect 2 pins to + and one to rpm adjustment pod.

Thanks for your help guys.

Hi Joe,

Does this mean there is NO WAY to speed it up as 1.5K out is unusable.

thanks
Daniel