Looking at seeing if Dellow do a conversion kit, they do one for the Hilux with the same gearbox and as far as I can see, their kit doesn't extent the shaft, rather a whole new bell housing and clutch to suit the Toyota box and fork setup. The current setup, the engine is only about 50mm from the ra...

That's basically the same bs conversion, Mark's 4x4 one. They simply don't work as intended. The bearing mounts to a big steel tube that slides in and out of a webbing cast into the bellhousing/adapter housing. It always jams, gets dust and crap in it, jams again and the bearing flops around. I had ...

So, hit a dead end with the slave sizing. So my other options is to cut and weld the input shafts together using aT5 donor shaft. But that depends if the T5 one will fit through the Toyota font seal or not. The last option is to have a custom flywheel with the face extended some 70+ mm back and use ...

I'll be getting a machine shop to do all the work. I don't have the equipment or the means to do it at home.

I could make it work with 38mm. I plan to turn it down anyway as part of it already has a narrower section at 34mm but it's exactly not where I want it to be narrower, actually the whole female part of the shaft needs to be the thinner diameter. Will heat treating really be necessary? I already had ...

Nah, it's a complete cluster f**k that fork setup due to how far from the engine the trans actually is and the weird double bell housing with a spider cast into the conversion bellhousing that hold a long sliding metal tube that houses the bearing. I re-engineered it, it was off it's face but just t...

Hi all, I am trying to locate a concentric slave with an ID of 40ish or more mm, maybe like 45mm ideally but I have come up empty handed after looking into this a few times over the last year or so. My nephew's 4Runner has been off duty for mostly 3 years now due to crap quality conversion from Mark...

I saw years ago there where like these models that gave BT and other functionality to old classic radios. I am sure there are much more feature packed modules you'd be able to get now days. But you need to know the basics of the radio schematics or be able to figure it out to solder in the in and ou...

Sounds like agony

I suppose all you can do is occupy your mind until you can't.

Thanks for that! Yes, VP has only 3 studs on the tower, but I was looking at the driver side since mine is a 6 and there is no room on the pass side for anything on the tower because of the intake pipe and AC stuff. It will only be for a catch can or two depending on blow by requirements on the engi...