I can not send private msgs. could someone please PM me, I am after 2 vt memory adaptors and 4 27c010 memcals.
thanks

Car is done and a very happy customer, would have not been able to achieve these results without all your support guys, thankyou. So stock vs from 120rwkw to 138rwkw, issue with dtc94 was computer not having a speed signal due to having t5 fitted not getting so had to bypass ecm and go straight to c...

worked a treat VL400 now I cant disable DTC94 m/t vehicle speed sensor failure to get engine light off, it was auto which has been converted to manual, I cand seem to fine DTC94 in my flags using VS V6 v1.24 $51.xdf. it only goes up to DTC 93.

heres the bin from the flash tool. I managed to connect to vehicle with flash tool while in car selection with "disable BCM chatter" unchecked. Burning with GQ-4X with zero offsets at low speed burn, by clean memcal I meant erased stock vs v6 memcal which blank checked fine. seems to me th...

Chip i am trying to burn is a stock vs v6 memcal going under 27c010.

thanks VL400 bench worked in setup, now I cant burn a clean memcal to run after extracting the bin with flash tool

ok got it tuned, now new problem, cant get the flash tool to work, see pic attached. what settings do I need for VS V6 PCM? ive set to vs in vehicle with USB adl using VL400s OBD2 plug and lead, can not get silence to extract data. im so close now this is very frustrating. VL400 Edit: Resized your p...

didn't you say in a previous post that the car wont run and the fans come on etc ? if that's the case its nothing to do with tunerpro ... its a fault in the memcal side of things .... you only usually get limp mode (fans on and no run) if there is an issue with the program on the memcal ..... do yo...

how can I connect without the OSEplugin?

tried connecting with stock memcal and wont connect through TP or flash tool. had it running for about 3 seconds on last NVRAM burn but cant get damn computer paired with vehicle to tune and adjust.