Most 202's built well with tripple webers have a runner length of 12" plus the ram tube approx 14 inch. They are making max torque around 5500 to 5800. This said im hoping with my short runners approx 10 to 11 inch i can make torque to 6500. Will be a pretty bent engine im building. i think im ...

No they are called ultraflow. Very rare setup and info on them is scarce. Hope they work ok.

This is the manifold in question.
The holes for vac can be seen, so if i do this 1/2 inch tube idea and until shows on map, that is right length for use to map or then the tank is fitted to the vac tube then the map?

I do like the vac tank idea, i have a vac point on each TB that will do fine for this job
I'm just tying to cover every angle.

Does the VN TPS have a linear range for alpha-n to work on other type ECU?
If i was to install a plenum and put a MAF on it would it work That way?

Hi im just new to the forum but it seems to be the place for me. I have an ITB setup for my 202 12 port. Can i and would you recomend the use of delco ECU. My ITb's use a VN tps and i am pretty good at wiring and electrical. It also uses vn fuel injectors. Converting 202 dizzy to camira module or cr...