Search found 10 matches
- Fri Jun 28, 2019 4:08 pm
- Forum: Holden ALDL ECUs
- Topic: Fail to start after writing cal
- Replies: 4
- Views: 2575
Re: Fail to start after writing cal
Hearing you fellas, cheers! I had gone back to stock but still getting a no start. Basically it was that flooded and the spark so weak i was getting a very rare single cylinder fire. When i finally twigged to the fuelling issue i pulled the plugs and confirmed excess fuel and found the worn plugs. A...
- Tue Jun 25, 2019 4:59 pm
- Forum: Holden ALDL ECUs
- Topic: Fail to start after writing cal
- Replies: 4
- Views: 2575
Re: Fail to start after writing cal
Risking looking like a fool I'm going to own up to my mistakes and add in where i went wrong and other things i found. First of all my mistake as i was trying to adjust injector base rate was reading it as g/ms and not ms/g. So while thinking i was allowing for larger injectors by upping the value i...
- Tue Jun 25, 2019 1:27 pm
- Forum: Holden ALDL ECUs
- Topic: Fail to start after writing cal
- Replies: 4
- Views: 2575
Fail to start after writing cal
After writing a new tune in the vx (vy l67 swapped) it fails to start, it tries but misses and smokes the times it does fire. Have read the FAQ about checksum correction and no result. (OSE flash has "autofix checksum" ticked). Not showing a checksum error while cranking either. This has h...
- Mon Jun 24, 2019 2:00 pm
- Forum: Holden ALDL ECUs
- Topic: trouble with vs v6 auto .bin with VATS turned off.? maybe
- Replies: 9
- Views: 4746
Re: trouble with vs v6 auto .bin with VATS turned off.? mayb
May completely wrong but my last starting issue was earth related, check down near the transmission cooler lines and the one up the back passenger side on the block.
I was also showing 7v on pin 9 at the comms port.
May eliminate one potential issue
I was also showing 7v on pin 9 at the comms port.
May eliminate one potential issue
- Sat Jun 22, 2019 11:40 am
- Forum: Holden ALDL ECUs
- Topic: Cal and bin write fails on ose flash
- Replies: 9
- Views: 4053
Re: Cal and bin write fails on ose flash
**update** SO issues resolved and pcm happily flashing on bench, threw the pcm back in the wagon. had a high refernce voltage on pin 9. tracked that down to a faulty earth, got it started back on the l36 tune then melted an earth wire on the next start, found another earth that had come loose, recti...
- Thu Jun 20, 2019 4:29 pm
- Forum: Holden ALDL ECUs
- Topic: Cal and bin write fails on ose flash
- Replies: 9
- Views: 4053
Re: Cal and bin write fails on ose flash
Due to my constant failure of trying to write cal/bin in the vehicle I've dodgied up a bench flash harness that is showing at least 1 healthy pcm, ive succesfully saved 4 bins from it now and only once had an issue with silencing chatter. I have been doing a hard reset after each function with good ...
- Tue Jun 18, 2019 11:29 am
- Forum: Holden ALDL ECUs
- Topic: Cal and bin write fails on ose flash
- Replies: 9
- Views: 4053
Re: Cal and bin write fails on ose flash
New pcm, still getting "no response. Resending write request"? Is there possibly a comms issue or some testing i can do to make sure it isn't a physical fault in the car? I will get one or 2 sections to write then it will show the above failure a few times then write a few more? No consist...
- Mon Jun 17, 2019 8:36 pm
- Forum: Holden ALDL ECUs
- Topic: Cal and bin write fails on ose flash
- Replies: 9
- Views: 4053
Re: Cal and bin write fails on ose flash
No, due to the circumstances i had to run the vx flash pcm at the time. I do still have the vy L67 memcal pcm sitting there! I tried just modifying the stock bin and writing that cal to suit. What other bin could i use being an l67 with a flash pcm? Or is there a better way using the memcal pcm? Had...
- Mon Jun 17, 2019 5:44 pm
- Forum: Holden ALDL ECUs
- Topic: Cal and bin write fails on ose flash
- Replies: 9
- Views: 4053
Re: Cal and bin write fails on ose flash
It's an envious customs cable.. didn't have any speed issues reading bins previously.
- Mon Jun 17, 2019 1:20 pm
- Forum: Holden ALDL ECUs
- Topic: Cal and bin write fails on ose flash
- Replies: 9
- Views: 4053
Cal and bin write fails on ose flash
Hi all, been a long time guest stalker of the forums, this last week I've been trying to adjust an ecotec tune to suit the l67 I've swapped into a vx wagon. Problem is i have only been able to upload 2 cal tunes, everytime i have tried it fails and drops out. I have tried disconnecting the battery a...