ben_att wrote: I got onto a bloke near Newcastle who is much more forthcoming and not arrogant like the other bloke and does CAN conversions for LS motors into other cars, so I've sent him a BCM, PIM and Cluster, sounds promising. Will let you know how it goes.

Any progress on this?

Is anyone aware of any RP1210 compatible Data Link Adapters that are cheap (around 100 AUD) Im looking to be able to connect to an EMP WP32 pump for diag and programming purposes - https://www.emp-corp.com/product/wp32-electric-water-pump/ On page 13 - it says a their USB/TTL convertor can be used b...

If you guys are talking about the little module to the lower left of the shifter thats the tach module mentioned in the initial image.

Interesting, that looks like two computers, an LS1 computer and a E67, unless I'm looking at that wrong, the loom also looks like it has the plugs on it for both computers, there's a VF BCM there and another module on the lift can't zoom in enough to read it. I got onto a bloke near Newcastle who i...

I recall seeing this a few years back.
assuming it was the same project..

Completely unrelated I built a 5v arduino pro micro + mcp 2515 to try and do aldl to can (rather than the other way around) for a can data logger to work on 12P. I got it working on the bench properly, then it kinda stalled and thats where its sitting. The speed is pretty slow, though its hard to t...

Hi,

Does anyone have any can data captures from around a 2015 mustang?
Im looking to use a Ford Mustang Electronic Power Steering Assembly in a non road going car but need to know the can frames the rack is looking for in order to behave correctly.

Thanks in advance

Thanks for the table showing the breakdowns of the bytes and bits. Im trying in a Vx HSV (lux bcm) to trigger the low speed fan via the bcm and have tried to inject the below using ose tool. TEST TX- 41,63,11,11,40,90,19,50,10,76,DB,90,11,11,5B,11, CHECKSUM (Note: POST EDITED) All things are working...

Can anyone share what needs to be injected into the bus to trigger the low speed cooling fan via the bcm? On VR/VS there is a specific request data frame sent from pcm to bcm, followed by an acknowledgement from bcm to pcm. On VT onwards the request is part of the data that is broadcast by the PCM ...

Can anyone share what needs to be injected into the bus to trigger the low speed cooling fan via the bcm?