Search found 4 matches
- Mon Apr 26, 2021 1:27 pm
- Forum: Tools
- Topic: PowerPCM_Flasher: my tool for E38 and E67
- Replies: 258
- Views: 276107
Re: PowerPCM_Flasher: my tool for E38 and E67
Guessing something is wrong with the bin, post it up here so we can check it and go from there.. Kewlio, any help would be appreciated, bin attached. Original and then HexEdit and tool sum corrected attached. Hint look for ID: 12635735 SUM: 0x7E6A and ID: 12635733 SUM: 0x39D2 If it turns out to be ...
- Sun Apr 25, 2021 12:59 pm
- Forum: Tools
- Topic: PowerPCM_Flasher: my tool for E38 and E67
- Replies: 258
- Views: 276107
Re: PowerPCM_Flasher: my tool for E38 and E67
RonVC wrote:Two HexEdit attempts cause ECM to go into limp mode, then upload original ECM binary recoversRonVC wrote:Attempted to read/write same bin E67 with MDI2 and now Vehicle will not start.
Must be doing something wrong with the bin edits or the sums are wrong. .
- Sun Apr 25, 2021 5:38 am
- Forum: Tools
- Topic: PowerPCM_Flasher: my tool for E38 and E67
- Replies: 258
- Views: 276107
Re: PowerPCM_Flasher: my tool for E38 and E67
Attempted to read/write same bin E67 with MDI2 and now Vehicle will not start. Let ECM sit for maybe 30 minutes, reflash original bin, engine now starts... Looking for some help in steps to be followed to bin edit, use the utils fix sum function and re-upload to vehicle. Went into P601 mode.... may...
- Sun Apr 25, 2021 5:03 am
- Forum: Tools
- Topic: PowerPCM_Flasher: my tool for E38 and E67
- Replies: 258
- Views: 276107
Re: PowerPCM_Flasher: my tool for E38 and E67
Attempted to read/write same bin E67 with MDI2 and now Vehicle will not start. Any suggestions, not sure how to use recovery? initialising Tool J2534 PassThru Bosch - MDI... NOT ok: init: 8 initialising Tool J2534 PassThru Bosch - MDI... ok. connecting... start diagnostic session (0x10 0x03)...ok. d...