Search found 143 matches
- Thu May 09, 2024 2:35 pm
- Forum: Bosch ECUs
- Topic: E67 to T87/T87A TCM interface needed
- Replies: 86
- Views: 14213
- Tue May 07, 2024 2:29 pm
- Forum: Holden ALDL ECUs
- Topic: Throttle crack / Tip-in Rich Lean Spike tuning help
- Replies: 6
- Views: 1426
Re: Throttle crack / Tip-in Rich Lean Spike tuning help
I think my approach to tuning VE was wrong. I'm road logging wide band data. I would go on long drives to get a lot of data and simply just save the averaged VE to all cells. This averaged data seems way too lean for load conditions (low rpm) so I decided to cherry pick data from the logs where the...
- Tue Apr 30, 2024 12:00 pm
- Forum: Bosch ECUs
- Topic: E67 to T87/T87A TCM interface needed
- Replies: 86
- Views: 14213
Re: E67 to T87/T87A TCM interface needed
Good lad!
- Sat Apr 27, 2024 7:26 pm
- Forum: Engine/Transmision Mechanical
- Topic: Can't find a large ID concentric slave, do they even exist?
- Replies: 16
- Views: 1135
- Fri Apr 26, 2024 11:59 pm
- Forum: Engine/Transmision Mechanical
- Topic: Can't find a large ID concentric slave, do they even exist?
- Replies: 16
- Views: 1135
Re: Can't find a large ID concentric slave, do they even exist?
Put a barra in it and be done with it.
- Thu Apr 25, 2024 6:56 pm
- Forum: Bosch ECUs
- Topic: E67 to T87/T87A TCM interface needed
- Replies: 86
- Views: 14213
Re: E67 to T87/T87A TCM interface needed
Not ideal. Would you be able to shoot over the other 2? If you need a hand to spread the load $ for the other standards you need I'm happy to buy a couple.
- Thu Apr 25, 2024 5:24 pm
- Forum: Bosch ECUs
- Topic: E67 to T87/T87A TCM interface needed
- Replies: 86
- Views: 14213
Re: E67 to T87/T87A TCM interface needed
I've got 8777 if you need it.
- Thu Apr 25, 2024 6:57 am
- Forum: Bosch ECUs
- Topic: E67 to T87/T87A TCM interface needed
- Replies: 86
- Views: 14213
- Wed Apr 24, 2024 8:18 pm
- Forum: Engine/Transmision Mechanical
- Topic: Can't find a large ID concentric slave, do they even exist?
- Replies: 16
- Views: 1135
Re: Can't find a large ID concentric slave, do they even exist?
Disclaimer, I'm a home hack with youtube degrees. I would let them know the application and follow their advice.
- Wed Apr 24, 2024 5:06 pm
- Forum: Engine/Transmision Mechanical
- Topic: Can't find a large ID concentric slave, do they even exist?
- Replies: 16
- Views: 1135
Re: Can't find a large ID concentric slave, do they even exist?
For perfection yes. The heat treatment usually hardens as a layer as opposed to all the way through the material. Once you cut through it on the lathe it's gone. The inside bore will obviously still be hard which is where all the work is being done. Are you turning it down yourself? You might need t...