https://pcmhacking.net/forums/viewtopic.php?t=7887&start=20 You should have got back to me in 2022, was not sure how you got on. There is bound to be more than the Map sensor settings in your ADX which needs to be changed. Kalmaker often makes changes which are not compatible with Holden bins a...

Unfinished RT VX VY PCM Possible 160 fps
No time to complete.

Yes that makes perfect sense.

Still going with this problem.


Oxygen sensor voltage seems way too low.

Have you used any Silastic on this engine any where. Maybe the Oxygen sensors have become poisoned.

There are some very cleaver people on this forum.

Yes hard ware ( PCM's P01 and P59) are different inside. What size is your bin file you wish to use?

The daughter boards are still for sale.

The board comes in two versions 0.5 Meg for 0411 (P01) PCM and 1.0 Meg for (P59) PCM.

If you install the 0.5 Meg board on a 0411 it will be 0.5 Meg flash.

I posted this on a previous thread. Could use a squirt of WD40 with the following procedure. It's easy to test to see if the injectors are stuck. Just get a 1.5V Volt single cell D battery or similar and make one permanent connection to the injector and with the other connection flash it on and off ...

I've noticed that only 2 of the plugs have shown evidence of fuel being present during this process. Leaves me with only one possible thing.... stuck/rooted injectors. About the only thing that hasn't been replaced or reconditioned. When you say only 2 of the plugs have shown evidence of fuel being...

Thanks Antus and Pete I will raise a ticket with Malwarebytes and let you know what I find out.



1/07/2023 I raised a ticket yesterday with Malwarebytes and over night the problem was fixed. They gave no explanation on the cause.

Thanks to all that gave advise.