Search found 37 matches
- Mon Jul 22, 2013 11:41 am
- Forum: Hardware
- Topic: falcon crank angle sensor
- Replies: 9
- Views: 6854
Re: falcon crank angle sensor
I just measured the resistance between the two pins, the holden abs sensors measured 1682 where as the ford sensor only measured 340. I guess this means i cant use the ford sensor?
- Mon Jul 22, 2013 12:00 am
- Forum: Hardware
- Topic: falcon crank angle sensor
- Replies: 9
- Views: 6854
Re: falcon crank angle sensor
Im not sure? is there an easy way to tell? The tip is magnetic just like the holden abs sensors..
- Sun Jul 21, 2013 8:35 pm
- Forum: Hardware
- Topic: falcon crank angle sensor
- Replies: 9
- Views: 6854
falcon crank angle sensor
Can anyone confirm whether the ford falcon straight 6 crank angle sensor is compatible with a delco DIS set up? It has two wires just like a holden ABS sensor but has two lugs on its side making it easier to mount than an ABS sensor. I don't want to go to the effort of making a bracket for it if it ...
- Wed May 29, 2013 4:55 pm
- Forum: Members Rides
- Topic: Mrfiat's fiat 131
- Replies: 73
- Views: 39727
Re: Mrfiat's fiat 131
sweet as, thanks!
- Wed May 29, 2013 4:22 pm
- Forum: Members Rides
- Topic: Mrfiat's fiat 131
- Replies: 73
- Views: 39727
Re: Mrfiat's fiat 131
Man im confusing the shit out of my self. Ok, so this is right then...?
- Wed May 29, 2013 4:06 pm
- Forum: Members Rides
- Topic: Mrfiat's fiat 131
- Replies: 73
- Views: 39727
Re: Mrfiat's fiat 131
I edited my post too. It was set to 10 degrees retarded before? now its advanced?
- Wed May 29, 2013 2:28 pm
- Forum: Members Rides
- Topic: Mrfiat's fiat 131
- Replies: 73
- Views: 39727
Re: Mrfiat's fiat 131
Ok im about to mark out my crank pulley for the trigger wheel. Ive added 10 degrees static advance. Can some one confirm what ive done here is right? Crank is set to TDC and is spinning clockwise. [EDIT]
- Sat May 18, 2013 2:36 am
- Forum: Members Rides
- Topic: Mrfiat's fiat 131
- Replies: 73
- Views: 39727
Re: Mrfiat's fiat 131
Inner west0081(2) wrote:Where in Sydney are you located??
- Fri May 17, 2013 1:49 am
- Forum: Members Rides
- Topic: Mrfiat's fiat 131
- Replies: 73
- Views: 39727
Re: Mrfiat's fiat 131
Can anyone recommend a place where i can get some alloy welding done in the Sydney area? I want to get my manifold done.
- Mon May 06, 2013 5:13 pm
- Forum: Members Rides
- Topic: Mrfiat's fiat 131
- Replies: 73
- Views: 39727
Re: Mrfiat's fiat 131
The pulleys are both cast iron and one piece...so yeah ill be better off bolting a wheel to the pulley rather than welding. Moving the altenator wont be hard and the waterpump pulley is also removable so making a spacer wont be too hard. Any tips on machining the slots into the pulley? How did you d...