Previously the wiring was P clipped to the underside of the fuel rails with some M5 cap screws. As you might imagine they weren't very easy to access. Machined a small pocket around the holes. https://img.v8comp.co.nz/Torana/20231014_123614.jpg And used them to locate a stainless bracket. These will...

I have one of those in the feed side rail


Perhaps with the electronic pressure sensor I'll be able to tell whether it achieves much?

Thanks guys, nothing particularly exciting today I'm afraid. As far as I know the old fuel pressure reg was working, but it is 30 years old so would be a shame to put together a new EFI system and have problems with it later. I like the Radium engineering pieces, quite pricey but then when you compa...

To get the throttle pedal in the right position the original bracket needed to be removed, a bit of careful die grinding in a tight space removed the welds and have put that aside. The new pedal requires a new bracket as it needs to be positioned straddling the upper firewall and the inner wheel wel...

Made a bracket for the filter and painted the modified bird bath. https://img.v8comp.co.nz/Torana/20230924_170038.jpg Made up some little brass crush tubes to suit these reinforced rubber rocker cover gaskets. Hopefully these are the right length to allow properly tightening the bolts with just a li...

Thanks for the kind words guys. I definitely get a kick out of making things myself.

The next piece of the puzzle is actually connecting it to the throttle body, and I wanted a reasonable transition. Trying to get better with the aluminium casting, 3D printed a basic part with some extra for machining. https://img.v8comp.co.nz/Torana/20230917_092324.jpg So far so good. https://img.v...

Made up a new piece so it will effectively become a drop base to provide space for everything. https://img.v8comp.co.nz/Torana/20230909_111837.jpg Well, almost. https://img.v8comp.co.nz/Torana/20230910_132533.jpg Mounted so that the filter element and seal edge are in the same position as before. ht...

I have three little boxes of the same size that need mounting in the same spot. 3D printed some spacers so I can stack them up. https://img.v8comp.co.nz/Torana/20230826_112214.jpg https://img.v8comp.co.nz/Torana/20230826_112657.jpg Also finally decided it was time to start cutting wiring to length a...

I think you're nearly there, the number is 1/42705