[Information] ALDL Basics

160 And 8192 Baud Aldl
User avatar
Posts: 9694
Joined: Sat Feb 28, 2009 9:05 pm
Location: Tenambit, NSW

Re: [Information] ALDL Basics

Postby Holden202T » Tue Mar 31, 2015 12:30 pm

no but it should work! I was almost going to use this to get a speedo on my trimatic equipped setup but found an alternative solution.

User avatar
Posts: 223
Joined: Sun Jan 25, 2015 4:21 pm
Location: Sydney

Re: [Information] ALDL Basics

Postby j_ds_au » Thu Apr 02, 2015 11:59 pm

matt304 wrote:I did not have the RS232 Echo box checked. Hard ware is not connecting.Saying cable is found. Bottom of screen is "Not Emulating" "Hardware not found" "DA:Not Connected. Connected to car again. Not working. Checkes DLC in car. Has power and earth. All looks ok

The Echo check box should be selected. "Saying cable is found" is good. Does it also find the cable when plugged into the car, with the ignition in the Off position? (That would also be good.) Finally, it may be helpful to know more about this cable.

Joe.

User avatar
Posts: 4988
Joined: Sun Mar 01, 2009 2:54 pm
Location: Perth, WA

Re: [Information] ALDL Basics

Postby VL400 » Mon Apr 06, 2015 1:12 pm

matt304 might have this sorted I suspect, was in 2012!

User avatar
Posts: 223
Joined: Sun Jan 25, 2015 4:21 pm
Location: Sydney

Re: [Information] ALDL Basics

Postby j_ds_au » Tue Apr 07, 2015 8:47 am

VL400 wrote:matt304 might have this sorted I suspect, was in 2012!

Oops! This thread had come back to life, but I forgot to check the date of that particular post. My bad.

Joe.

User avatar
Posts: 223
Joined: Sun Jan 25, 2015 4:21 pm
Location: Sydney

Re: [Information] ALDL Basics

Postby j_ds_au » Mon Dec 31, 2018 12:21 am

Hi Ryan,

In the opening post, it states :

"VR/VS ... This data bus allows for only one device to communicate at a time and connects all the major modules – BCM, ABS, SRS, ECM etc."

To avoid confusion, it would be helpful to note here that in the VS, the SRS has its own separate data bus.

Joe.

Previous

Return to ALDL, OBDII Logging and Scanning

Who is online

Users browsing this forum: No registered users and 4 guests