VS $51 3rd gear lock tcc unlock command

[VX L67 Getrag]

I reckon I must do this every time I try & run a car on the dyno!

But copying the commands from old adx or using the command generator is working?

I have it as F5 58 04 81 00 with 2E as 2's compliment checksum
The generator comes up with the full 18 byte message & no checksum necessary but what it says it is doesn't work I even made a macro command with listen for silence for either of the commands but no luck?

TIA & any ideas welcome

This is what the generator came up with;
0xF5 0x6B 0x04 0x81 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x1B

But I actually have a feeling the VS doesn't need as many bytes?

[VX L67 Getrag]

I gave up last night came back in this morning to retry & tried new command;
F5 68 04 01 00 00 00 00 00 00 00 00 00 08 00 96

Still to no avail, I again tried with a macro command with listen for silence to but same deal?

Surely someone can help or has ideas?

[antus]

Try this?

http://pcmhacking.net/forums/viewtopic. ... 861#p34862

Not sure if the pcm id is the same off the top of my head, if it isnt change it and make sure the checksum is right.

[VX L67 Getrag]

Yeah I thought about that but pretty sure there different & need to unlock TCC, but guess I can do that with enable temp in cal!

Thanks will give it a go!

[VX L67 Getrag]

Yeah bingo, did the trick, should have tried it earlier thanks Antus!

I reckon I could add in the 81 after 04 & get the tcc unlock command sorted with new checksum obviously, but just cal disabled!

Thanks again