To do the memory on the cluster, ull either need to pull the info from the eeprom using a programmer such as a GQ-4. Or if the cluster doesnt have an eeprom (has the NEC chip) then youll need more special equipment or software to pull the dump.dmenace wrote:LOL i'm such a n00b.
What does the Get EEPROM option on flashtool do exactly?
EDIT: Never mind i looked it up. It pulls the data off the PCM
Need help with VX S1 V6 - Error Code 24 and 20
Re: Need help with VX S1 V6 - Error Code 24 and 20
Your Local Aussie Reverse Engineer
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
Re: Need help with VX S1 V6 - Error Code 24 and 20
Hey Guys,
I've changed the Cluster with another unit with the same part number.
The SERV Error message has gone
Tacho is correct
Fuel Gauge, not sure about yet.
But i'm still getting the SRS light and Audible beeping on start up.
Will plug in the laptop tonight to see what the deal is.
I've changed the Cluster with another unit with the same part number.
The SERV Error message has gone
Tacho is correct
Fuel Gauge, not sure about yet.
But i'm still getting the SRS light and Audible beeping on start up.
Will plug in the laptop tonight to see what the deal is.
Re: Need help with VX S1 V6 - Error Code 24 and 20
do you have an airbag fitted? if you dont then you'l need it changed, or if yours is only drivers airbag but the cluster came from a car with dual airbags then the config will need to be changed.
Re: Need help with VX S1 V6 - Error Code 24 and 20
Hmm i hope not lol!
I've got the single airbag on my car....
I've got the single airbag on my car....
Re: Need help with VX S1 V6 - Error Code 24 and 20
Yeh if airbag config in the cluster doesn't match your car then itl need reconfiguring tech2 can do this.
Re: Need help with VX S1 V6 - Error Code 24 and 20
Guys,
I sent the FB,56,A,A5 command via the flashtool and the SRS light has gone so far.
Bloody great stuff!!!!
I sent the FB,56,A,A5 command via the flashtool and the SRS light has gone so far.
Bloody great stuff!!!!
Re: Need help with VX S1 V6 - Error Code 24 and 20
Just a small update.
Fuel gauge is still out.
So i'm not sure what is happening, when the pump was replaced they asked for my VIN.
Anyways i can live with it as it is. I'll just go by km's instead of the gauge.
Also just wanted to say a massive thanks from Shane at Level 3 Patch Looms. Bloke went above and beyond to help me out.
Fuel gauge is still out.
So i'm not sure what is happening, when the pump was replaced they asked for my VIN.
Anyways i can live with it as it is. I'll just go by km's instead of the gauge.
Also just wanted to say a massive thanks from Shane at Level 3 Patch Looms. Bloke went above and beyond to help me out.