Tech 1 cable pinouts
12 posts
• Page 2 of 2 • 1, 2
Re: Tech 1 cable pinouts
MAGP wrote:I wasn't sure about it. I thought it could be possible but I didn't want to use the wrong pin and, possible, destroy a mint Tech 1 ...
Well, beware the 160 baud ALDL signal is 12V, so be sure the Tech 1 input can handle this (probably it can, I don't have any info. on it, but I thought I'd highlight this just in case).
Joe.
Re: Tech 1 cable pinouts
On Tech1 self-test routine, there is a mention to a 5V serial line..
Considering it was advertised to be rugged, I believe that circuit is 12V tolerant. But I would not bet my money on that.
Considering it was advertised to be rugged, I believe that circuit is 12V tolerant. But I would not bet my money on that.
12 posts
• Page 2 of 2 • 1, 2
Return to ALDL, OBDII Logging and Scanning
Who is online
Users browsing this forum: No registered users and 2 guests