Kalmaker logging calculated VE

160 And 8192 Baud Aldl
Post Reply
VX L67 Getrag
Posts: 2877
Joined: Sun Aug 02, 2009 9:16 pm
Location: Bayside, Melbourne, Victoria
Contact:

Kalmaker logging calculated VE

Post by VX L67 Getrag »

I was just wondering if anyone knows the address for current VE for kalmaker map based software in the $A5 code so vt-vy L67(w55 to w96).

I found in the ose $11p code it's packet offset 0x22 so I used that & seems to lol about right but I just wanted to double check before I go tuning off those figures if there not correct.
VX L67 Getrag
Posts: 2877
Joined: Sun Aug 02, 2009 9:16 pm
Location: Bayside, Melbourne, Victoria
Contact:

Re: Kalmaker logging calculated VE

Post by VX L67 Getrag »

O.K. so I have been told from 1 of the moderators I "SHOULD" be able to figure it out, which I think I have but would like to have actual confirmation before I start basing my tune off the "POSSIBLE" what I know data log adreses...

So it looks like closed(or near closed TPS)is packet 22...

Then Main(non closed TPS) may be packet 26(which was MGC as now MAF is not being used it's now free) VE table may be packet 26?
VX L67 Getrag
Posts: 2877
Joined: Sun Aug 02, 2009 9:16 pm
Location: Bayside, Melbourne, Victoria
Contact:

Re: Kalmaker logging calculated VE

Post by VX L67 Getrag »

So it turns out the mgc data packet isn't correct for main VE table, so I have no idea without trying every single packet & see if it come close to what is commanded(but who knows if they're grabbing multiple areas for the 1 packet???).
Post Reply