Workaround for 24/7 power requirement

Thought Of A Good Feature To Add Tell Everyone About It Here
Posts: 12
Joined: Sun Sep 04, 2016 9:16 am

Workaround for 24/7 power requirement

Postby bbpanel » Tue Nov 19, 2019 10:07 am

This may be applicable to a lot of ECU/PCM's but I'm primarily interested in the P01 (0411) PCM. I have virtually no circuitry knowledge so if I'm crazy just say so. How difficult would it be to add non-volatile memory to store the data that is lost when the PCM is powered off? I'm sure there would be some OS programming involved as well. Wasn't sure if this had been addressed before so I thought I'd throw it out there for discussion. Thanks. -Bob

Site Admin
User avatar
Posts: 5835
Joined: Sat Feb 28, 2009 8:34 pm

Re: Workaround for 24/7 power requirement

Postby antus » Tue Nov 19, 2019 3:56 pm

it would be reasonably difficult as there is no plug in compatible nvram type IC (that I am aware of) that is a 5v parallel part of the same size as the IC. It would also break the factory flash process as the pcm will try and drive an intel IC and eg put 12v on the power pin, which will do damage for the nvram. ideally you would probably want to put your own pc data link software in for flashing updates, and just protect against the factory write routines which would fail.

These higher voltage (5v) parallel parts are hard to work with as most the newer hardware that sounds like it'd just work is usually designed for lower voltages on newer serial bus processors.

For what its worth the Moates road runner hardware pretty much did this, and I think dicks RTLS1 did something similar too. Other products like nistune also have taken the custom hardware approach and come up with a chip emulation solution which would not directly work here but some custom hardware with the same approach would work.
Have you read the FAQ? For lots of information and links to significant threads see here: viewtopic.php?f=7&t=1396

User avatar
Posts: 266
Joined: Sun Jan 25, 2015 4:21 pm
Location: Sydney

Re: Workaround for 24/7 power requirement

Postby j_ds_au » Tue Nov 19, 2019 7:04 pm

You'd need to rewire the PCM ignition/run supply input to a constantly-on battery supply line. But this would drain the battery much quicker than normal with the ignition off.

Joe.

Return to Hardware/Bin Feature suggestions

Who is online

Users browsing this forum: No registered users and 1 guest