Immortalities totally random thread

A place For General Chit Chat Etc
Posts: 2629
Joined: Thu Apr 09, 2009 12:31 pm

Re: Immortalities totally random thread

Postby immortality » Sat Feb 08, 2020 3:34 pm

Think I'll attempt a thermostat change tomorrow and finish flushing the engine. I think there is enough room to do the job with the TB off but leaving the elbow in place.

Posts: 2629
Joined: Thu Apr 09, 2009 12:31 pm

Re: Immortalities totally random thread

Postby immortality » Sat Feb 08, 2020 5:06 pm

... and I've been busy out the back of the place. Finally making progress on my pizza oven but then I strained the shoulder so have not made any more progress since last weekend. Only thing left to do now is enclose the sides, make some cabinet doors and then finish the bench tops (tiles).
WhatsApp Image 2020-02-02 at 20.35.49 (1).jpeg

(forgive the shitty phone pic)

Makes a good fire though and cooks a pizza in a few minutes :)
WhatsApp Image 2020-01-24 at 18.44.55.jpeg

User avatar
Posts: 9890
Joined: Sat Feb 28, 2009 9:05 pm
Location: Tenambit, NSW

Re: Immortalities totally random thread

Postby Holden202T » Sat Feb 08, 2020 8:49 pm

Nice pizza oven!!

Posts: 2629
Joined: Thu Apr 09, 2009 12:31 pm

Re: Immortalities totally random thread

Postby immortality » Sun Feb 09, 2020 10:29 am

Thermostat change done. spent ages trying to get the original hose off but cut the bugger in the end and put on a new one. Much faster, should have done that from the start. Got the system bled, easy job with the funnel on it. Using straight water and will do another flush and fill with additive this evening. New thermostat is controlling the temp around the 82° with the fluctuating a few degrees up and down as it adjusts flow. Road test soon. Definitely not a job you would want to do with a stock elbow and no spacer under the blower.

viber_image_2020-02-09_12-56-09.jpg


Holden202T wrote:Nice pizza oven!!


Cheers mate :)

Posts: 2629
Joined: Thu Apr 09, 2009 12:31 pm

Re: Immortalities totally random thread

Postby immortality » Wed Feb 26, 2020 1:17 pm

Did another flush on the Calais and topped off with water and Pentrite 10 tenths additive. Engine coming up to temp nice and not running to cool. Call that a win.

Too bloody hot in the house today so went down to the garage and stripped down a brand new 304 GMB water pump ready for modification. When I pressed out the bearing assembly I found this...
WhatsApp Image 2020-02-26 at 13.32.09.jpeg

The bore is badly galled up on one side. I suspect it's not been pressed in straight and if the shaft isn't running true in the bore than it's going to fuck the seal in short order. I bought 2 pumps at the time so have pressed off the impeller on the 2nd pump and removed the back plate ready for mods.

Previous

Return to Off Topic

Who is online

Users browsing this forum: No registered users and 5 guests