VS V6 Manual Odd Idle speed problem

A place For General Chit Chat Etc
Ken
Posts: 206
Joined: Tue Dec 17, 2013 1:05 am

Re: VS V6 Manual Odd Idle speed problem

Post by Ken »

Since the recent service of pump, filter and injectors, this thing barely flairs to just under 1000 rpm now, was creeping up to 1550+ before this last service.
Couldn't begin to imagine how the old parts influenced the idle flair like it did, though it seems to have none the less.
I didn't replace any hoses this service as they were all checked and replaced when I serviced the IAC..
User avatar
The1
Posts: 4694
Joined: Mon Jan 04, 2010 10:23 am

Re: VS V6 Manual Odd Idle speed problem

Post by The1 »

For a getrag VS V6 there is only one tune from the factory, there is a different single F XDF for it to. Attached is what i have for the xdf and factory CAL, is this what your using, it should be the listed CAL on the ECU.

BZPT0725
Attachments
VS V6 v1.04 $51F Getrag.xdf
(417.88 KiB) Downloaded 252 times
BZPT0725.BIN
(128 KiB) Downloaded 241 times
Ken
Posts: 206
Joined: Tue Dec 17, 2013 1:05 am

Re: VS V6 Manual Odd Idle speed problem

Post by Ken »

Yeah that's what I've been using, thanks mate.
Before this last service, I put the original un-touched memcal back in it to validate the flair wasn't something I induced into the tune, was the same.
User avatar
The1
Posts: 4694
Joined: Mon Jan 04, 2010 10:23 am

Re: VS V6 Manual Odd Idle speed problem

Post by The1 »

try the table IAC - MAX Throttle Flare steps, zero it out and see if it changes. If it happens at certain speeds try the Throttle follower gain table.

If you have datalogging check that IAC steps are around 30 mark at hot idle.
User avatar
antus
Site Admin
Posts: 8238
Joined: Sat Feb 28, 2009 8:34 pm
cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B
Contact:

Re: VS V6 Manual Odd Idle speed problem

Post by antus »

If the fixed xdf or the1s xdf is better than what we have here, we should move it in to the thread. viewtopic.php?f=7&t=5

The components to check or install in to a VS computer can be found by searching the FAQ for "Q. How can I convert my VS Auto PCM to accept a VSS signal from a T5 Manual?" and use the link to the thread. I'll also repost it here. viewtopic.php?f=7&t=1377&start=40#p15740
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
Post Reply