thanks
but judging by the file names
10/01 you programmed the engine control unit
25/03 power steering unit
since you did not program automatic transmission
naturally no files
Access to the GM portal in Australia (Holden)
-
- Posts: 380
- Joined: Thu Jan 16, 2014 12:41 pm
- cars: 2004 Colorado 4.8L swap
86/90 Jimmy 6.5L diesel swap
80 Chevrolet Silverado TBI swap
88dodge W100 LPG conversion
Re: Access to the GM portal in Australia (Holden)
Can you possibly get an Australian BCM filesHolden202T wrote:this is all i found.
for 2015 Holden Trax KL3BA7659FB194383
Re: Access to the GM portal in Australia (Holden)
I do not have a compatible TCM on the bench to get the required TCM files. SPS freaks out and wants one on bench before it will download the required files.
Your Local Aussie Reverse Engineer
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
-
- Posts: 380
- Joined: Thu Jan 16, 2014 12:41 pm
- cars: 2004 Colorado 4.8L swap
86/90 Jimmy 6.5L diesel swap
80 Chevrolet Silverado TBI swap
88dodge W100 LPG conversion
Re: Access to the GM portal in Australia (Holden)
If it is a t76 or t43 tcm I think I have a simulator for that. If that helps the op out.Tazzi wrote:I do not have a compatible TCM on the bench to get the required TCM files. SPS freaks out and wants one on bench before it will download the required files.