Sure does, this version supports:mattyjf01 wrote:Nice
I went a bit backwards Arduino J2534 then Elm
Does it support SW-CAN?
ALDL
VPW
CANbus Highspeed
CANbus gmlan
Basically all major GM protocols.
But can understand going backwards, I went ELM, to custom tool (years ago.. too expensive) then to j2534 tools. Now finally back to a custom tool although it’s finally affordable this time.
In saying the above, my coding ability is 1000x better then when I first attempted. The general command flow was good, but the way I dealt with various situations such as incomplete commands was horrendous haha.