FS: Ford Smartlock Bypass Module

Hardware and Software. If you have something to sell, post it here.
Posts: 319
Joined: Thu May 03, 2012 10:50 pm
Location: Castlemaine, Vic

FS: Ford Smartlock Bypass Module

Postby pman92 » Wed Jan 09, 2019 1:09 pm

This module is used to remove the smartlock anti-theft system on Ford Falcons:
EB2, ED, EF, EL, XG, XH and I believe early AU1. 6 cylinder or V8.
It will not work on later models that use the "smartshield" system.
Also suitable for engine conversions etc.

It will generate the smartlock signal required for the PCM to run independently without a BEM (body electronics module) or coded ignition keys.

Standard connection is easy. 3 wires: power, earth and signal.

There is also 2 extra wires. If desired, either or both can be used to connect the module to a simple kill switch / aftermarket immobiliser.
This will retain the factory anti-theft and use your kill switch or aftermarket immobiliser to control it.
One wire will disable when connected to ground, and enable when open or 12v.
The other wire will disable when connected to 12v, and enable when open or ground.

They are small is size (40x40x15mm) so can be cable tied to the wiring loom.
They are also available with or without mounting tabs.
Full installation instructions are included.

Express postage included Australia wide.

$110 each

Done3.jpg
Done3.jpg (120.89 KiB) Viewed 22 times

Done2.jpg
Done2.jpg (46.29 KiB) Viewed 22 times
VR-VY Holden BCM Simulator: LINK
Ford Smartlock Bypass Module: LINK

Return to For Sale

Who is online

Users browsing this forum: No registered users and 2 guests