FS: NVRAM PCM Conversion (VS Ecotec, VT V6/V8, VX/VY L67)

[VL400]

Will send you the instructions link, but there is no wiring to install the NVRAM board and flashtool can read/write the cal. For using the plugin can disconnect the BCM using info from here .. https://pcmhacking.net/forums/viewtopic.php?f=9&t=1990

[The1]

try the wiring section first

https://pcmhacking.net/forums/viewforum.php?f=32

[TTVN]

thanks guys
appreciate it

[eddyj08]

hey do you still have one of these and how much are they assembled? after one for my vs commodore as looking to supercharge it. and do you know of a tune which is set up for boost or one that can be used to just give an easier starting point?

[VX L67 Getrag]

My old 1's I have of these are a lot simpler that I got from you are they still o.k. to use or do they need to have all the updated gear on them?

[VL400]

The new ones stop the rare and random corruption that happened on some PCMs. If you dont have an issue then no need to update it

[VX L67 Getrag]

Yeah I do remember when I was using them in the past they did have random errors from time to time!

Thanks for the info though!

[VL400]

Your board is the very early development board. The issues you had were totally unrelated to the random corruption problem from aging PCMs and were instead the difference between VS and VT PCMs.

[Chuff]

Hi.

Will this NVRAM PCM Conversion work on the factory supercharged V6 motors found in Commodores?

Thanks.

[charlay86]

Yep sure will.