FS: NVRAM ECM Conversion (VN to VS but not VS Ecotec)

[Holden202T]

think of it like a normal computer in every way other than the added functionality of being able to change the tune while you drive.

[Heathmurray1986]

thats good another little add to my shopping list

[Mcgeek]

Just wondering if the RTP board will work with ds1230 nvram chips? i have a few sitting around. Cheers

[VL400]

Yeah it will, there is a jumper to select a ds1230. You lose dual bins though

[S1VNV6Hilux]

NVRAM ECM Conversion

NVRAM_ECM.png

Application: To suit any ECM from VN to VS (Not VS Ecotec). With a write enabled bin it allows for realtime tuning.
Kit Assembly: Full instructions supplied, basic soldering and kit building skills are required.
Installation Requirements: Solder a single wire to the ECM PCB, remove the original memcal and install the NVRAM board. The NVRAM comes pre-loaded with your choice of bin however an EPROM programmer that is able to program DS1245Y chips is recommended.
Cost: $130 in kit form or $150 assembled (subtract $40 from either price if you would like to supply your own DS1245Y), postage included.
Other Requirements: None, however a communications cable or comms board to allow 8192baud access to the ECM is required if you want to make changes.
Availability: Now
Ordering Information: PM me for more details or if you wish to order

hi im bit of a novice at this.. so will this avoid me having to run a vr manual ECM to get the higher 8192baud rate compared to the 160baud my vn ECM currently runs ? i need to be able to do real time tuning to bet better value from my VN V6 Hilux conversion.. i would like to have one setting for normal day to day driving and another for off road ??

[Holden202T]

the nvram conversion is needed to allow realtime tuning, but you also need a serial or usb interface to connect between the laptop and the ecm.

yes you can have dual maps or switch banks on the nvram to have completely different tunes on each section.

[S1VNV6Hilux]

the nvram conversion is needed to allow realtime tuning, but you also need a serial or usb interface to connect between the laptop and the ecm.

yes you can have dual maps or switch banks on the nvram to have completely different tunes on each section.

thanx heaps for the info Holden202

[envyit]

Hi mate do you still have these and do you also have a communications cable?

[VL400]

Will flick you a PM

[CHEQUERED TUNING]

Hi can you send me a link to where i can buy this gear for my tune shop on a regular basis? are you happy to supply?