Alloytec Bench Wiring Harness

Hardware and Software. If you have something to sell, post it here.
Post Reply
VX L67 Getrag
Posts: 2877
Joined: Sun Aug 02, 2009 9:16 pm
Location: Bayside, Melbourne, Victoria
Contact:

Alloytec Bench Wiring Harness

Post by VX L67 Getrag »

Howdy all,

I just managed to go & pick up a couple of engine harness's for the VZ E55 controller & 1 for the T42 4 speed controller for same model.

I can make them up into bench harness's if interested or can have as they are with all the wires still connected but only around 30cm cut off's!

With bench harness it will just be stripped back bare wire ends for 12v ignition, 12v batt, earth, Can Hi & Can Lo which leaves you to put whatever end you like on them, or I can wire a standard OBD plug in for extra cost if wanted.

PM if interseted
Post Reply