New custom ecotec 808 loom

Hardware and Software. If you have something to sell, post it here.
User avatar
Posts: 6268
Joined: Mon Oct 08, 2012 6:41 pm
Location: Kyneton, Vic

New custom ecotec 808 loom

Postby vlad01 » Sun Oct 21, 2018 4:20 pm

For sale a near completed custom 808 conversion loom for ecotec to suit VN-VR or others with some additional work.

Has all new connectors and wires on engine side.

WB under dash input connector for convenience

Purge solenoid for ecotec connected to a flex output.

Fire proof fiberglass braided protection and heat proof cloth based loom tape.

4 wire O2 support and wires already run but need installation for final length and position as goes with the untaped part, 2 ground wires and engine bay to loom plugs. All these need to be made according to routing in the engine bay.


Well over $600 spent on connectors, terminals, colour coded wires, protection, tape etc... and weeks of careful construction.

Had it for 4 years doing nothing and probably will stay like that since I no longer do any ecotec stuff for my personal cars.


Asking $500 plus postage. Can chuck in the plenum with MAT installed to suit and heads up on where to get plugs to finish it off, provide some terminals as well.

IMG_0419.JPG


IMG_0418.JPG


IMG_0441.JPG


IMG_0442.JPG


IMG_0443.JPG


IMG_0444.JPG
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.

Posts: 17
Joined: Wed Jun 27, 2018 11:26 am

Re: New custom ecotec 808 loom

Postby VSRaptor » Sat Jan 26, 2019 10:43 pm

Where did you position the mat sensor on the ecotec plenum?

User avatar
Posts: 6268
Joined: Mon Oct 08, 2012 6:41 pm
Location: Kyneton, Vic

Re: New custom ecotec 808 loom

Postby vlad01 » Sun Jan 27, 2019 2:04 pm

in the plenum in line with the TB at the far side. So it gets samples of the direct air as it tumbles around the top.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.

User avatar
Posts: 9629
Joined: Sat Feb 28, 2009 9:05 pm
Location: Tenambit, NSW

Re: New custom ecotec 808 loom

Postby Holden202T » Wed Jan 30, 2019 12:34 pm

mat.jpg

Posts: 17
Joined: Wed Jun 27, 2018 11:26 am

Re: New custom ecotec 808 loom

Postby VSRaptor » Sat Feb 02, 2019 12:01 am

I have seen some that had a bung welded into the lower manifold like the 304 V8. Mine I drilled and tap next to the throttle body on the car just removing the plenum cover, coil pack and throttle bracket.
Attachments
20180705_074120.jpg

Return to For Sale

Who is online

Users browsing this forum: No registered users and 2 guests