For sale a near completed custom 808 conversion loom for ecotec to suit VN-VR or others with some additional work.
Has all new connectors and wires on engine side.
WB under dash input connector for convenience
Purge solenoid for ecotec connected to a flex output.
Fire proof fiberglass braided protection and heat proof cloth based loom tape.
4 wire O2 support and wires already run but need installation for final length and position as goes with the untaped part, 2 ground wires and engine bay to loom plugs. All these need to be made according to routing in the engine bay.
Well over $600 spent on connectors, terminals, colour coded wires, protection, tape etc... and weeks of careful construction.
Had it for 4 years doing nothing and probably will stay like that since I no longer do any ecotec stuff for my personal cars.
Asking $500 plus postage. Can chuck in the plenum with MAT installed to suit and heads up on where to get plugs to finish it off, provide some terminals as well.
New custom ecotec 808 loom
- vlad01
- Posts: 7796
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
New custom ecotec 808 loom
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
Re: New custom ecotec 808 loom
Where did you position the mat sensor on the ecotec plenum?
- vlad01
- Posts: 7796
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: New custom ecotec 808 loom
in the plenum in line with the TB at the far side. So it gets samples of the direct air as it tumbles around the top.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: New custom ecotec 808 loom
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: New custom ecotec 808 loom
I have seen some that had a bung welded into the lower manifold like the 304 V8. Mine I drilled and tap next to the throttle body on the car just removing the plenum cover, coil pack and throttle bracket.