FS: Ford Smartlock Bypass Module

Hardware and Software. If you have something to sell, post it here.
Post Reply
pman92
Posts: 464
Joined: Thu May 03, 2012 10:50 pm
cars: HZ One Tonner
VE Ute
Location: Castlemaine, Vic

FS: Ford Smartlock Bypass Module

Post by pman92 »

This module is used to remove the smartlock anti-theft system on Ford Falcons:
EB2, ED, EF, EL, XG, XH. 6 cylinder or V8.
It will also work on most AU series 1 vehicles manufactured prior to June 7th 1999 (early series 1 only). These early AU vehicle's will NOT have the small "smartsheild" warning sticker on the rear side quarter windows.
It will not work on later model AU or BA that have the "smartshield" system.

It will generate the smartlock signal required for the PCM to run independently without a BEM (body electronics module) or coded ignition keys.

Standard connection is easy. 3 wires: power, earth and signal.

There is also 2 extra wires. If desired, either or both can be used to connect the module to a simple kill switch / aftermarket immobiliser.
This will retain the factory anti-theft and use your kill switch or aftermarket immobiliser to control it.
One wire will disable when connected to ground, and enable when open or 12v.
The other wire will disable when connected to 12v, and enable when open or ground.

They are small is size (40x40x15mm) so can be cable tied to the wiring loom.
They are also available with or without mounting tabs.
Full installation instructions are included.

Express postage included Australia wide.

$110 each
Done3.jpg
Done3.jpg (120.89 KiB) Viewed 17367 times
Done2.jpg
Done2.jpg (46.29 KiB) Viewed 17367 times
VR-VY Holden BCM Simulator: View Post
MrModule.com.au
Post Reply