I have a bench setup like this actually. Its a small frame with a 12V DC motor with a crank trigger mounted near the chopper wheel. Can also use a battery drill with variable speed, most will get at least 1000 rpm flatout. That EDIS setup throws out some spark powerBradGTV wrote:has anyone tryed attaching a crank trigger to a grinder, lathe or similar so it turns. then having the crank trigger mounted near it. then have power/earth onto the ingnition module and the crank sensor pluged in. then have 4 spark plugs with leads connected to the coils. would this set up produce a spark? (the ecu would not be connected) i have seen this test done using ford edis but wondering if i can do this with the delco. this way i can test cranks sensors until i get one that works.
Nice find on the Jackaroo too!