Astra G Simtec 70 EEPROM read

European GM ECUs and PCMs
Posts: 1
Joined: Thu Feb 08, 2018 1:39 pm
Location: Doonside, NSW

Astra G Simtec 70 EEPROM read

Postby Argosy » Sat Feb 10, 2018 8:47 pm

Hi,

I have an Opel Astra G series 1 (1998) with a Siemens Simtec 70 ECU. I am trying to write a C# program using KWP2000 commands and the ELM327 device to read the EEPROM to extract the 4 digit pin code. The commands to start the diagnostic session and seed/key commands work ok, however when I attempt to read memory, it returns an undocumented error:

Start Diagnostic Session: 0x10 81, returns 0x50 (success)

Request Seed: 0x27 01, returns 0x67 01 D1 C3 (success)

Send Key: 0x27 02 9B E5, returns 0x 67 02 34 (success, security access allowed)

Read Memory By Address: 0x23 10 00 00 02 (0x 10 00 = memory address, 0x00 02 = bytes to read), returns 7F 23 52, (7F = negative response, 23 = command sent, 52 = ?).

My information for the KWP2000 commands is from the document “General Motors Local Area Network Enhanced Diagnostic Test Mode Specification (GMW3110)”, where it states that start address can be 2, 3 or 4 bytes. I have tried sending 2, 3 and 4 byte length start addresses, but they all fail. Does anyone have any idea what the problem could be? Thanks.

Return to Euro GM ECUs

Who is online

Users browsing this forum: No registered users and 2 guests