Nitro’s Home Made Hydroplane

[Nitro Worms Profile]

Put the spanners and welders down for a bit and tried my hand at a bit of woodwork.

Some 6mm marine ply from bunnings and about 6 litres of epoxy and microsphere filler, some brass nails and other odds and sods and a few tins of nescafe 43 later, I emerged from my shed VICTORIOUS!! With this UNSINKABLE 8ft long, 4 ft wide, MASTERPIECE!!!

Heres a few build pics:

[Nitro Worms Profile]

[Nitro Worms Profile]

19188B7D-1315-4B5C-9F54-F669A10DDAF2.jpeg (23.7 KiB) Viewed 10639 times

https://youtu.be/9qqDuN_gHXY

The young bloke thought it was pretty good fun.

Thats a little whipper snipper motor I put on for him.

[Nitro Worms Profile]

Whacked a 15hp merc on there and got it registered.

Fun little boat, does 50km/hr and shes definitely a wet, wild ride in rough chop.

The Bow is airtight and the port and starboard sides of cockpit are also airtight separate chambers. You can fill the entire cockpit with water and still drive it.

https://youtu.be/FB-TO7IMaSQ

['quipt4it Profile]

That looks like too much fun.
Reminds me of those short and sweet Sprint Boats.
She gets up on the plane nice

[Nitro Worms Profile]

I’ve got a Yamato331 racing motor coming over from Japan in August for it. She should be good for about 110km/hr then. Give a few of these jetski and inboards a bit of a run for their money

[Gampy]

That's badass ...