Hi
I have a stock bin file out of my stock CJ lancer. I can not find any XDF files to use. Is there a way to write my own. Or some software that will make a XDF for me, or high light some address. That I can use. I'm mainly using tunerpro RT ECUflash Or pcm hammer.
Making a XDF
-
- Posts: 2882
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
Re: Making a XDF
CJ Lancer, what is the details & setup & why do you need to adjust anything?
Generally you'd need to get a base map layout from winOLS or ECMtitanium or anything that may have map locations & info(longest way is dissasembly but way too hard)... all depends on how much you want to spend & what you want to do.
There is a place out the called OldSkullTuning that sell tunerpro xdf's but doubt they'd support that & their files are locked.
Generally you'd need to get a base map layout from winOLS or ECMtitanium or anything that may have map locations & info(longest way is dissasembly but way too hard)... all depends on how much you want to spend & what you want to do.
There is a place out the called OldSkullTuning that sell tunerpro xdf's but doubt they'd support that & their files are locked.
-
- Posts: 1833
- Joined: Sat Aug 06, 2011 7:58 am
- cars: V8 VR Commodore BT1
LB Lancer 2L turbo & Delco
Starion TBI with Delco
Mitsubishi Lancer EVO4 track car
NA MX5
3 vintage motor bikes - Location: Padstow NSW
Re: Making a XDF
Have a look on the Evoscan website. There's a few listed but not sure if one is your car.
-
- Posts: 305
- Joined: Fri Jul 30, 2021 5:49 pm
- cars: 97 Corvette
92 Camaro
2005 Silverado
2001 Savana 2500
1998 c3500hd
1998 tahoe