setting Idle on the 12P code
Re: setting Idle on the 12P code
I think I will strip the whole throttle body down and give it a good clean and see how it goes
Re: setting Idle on the 12P code
Also check tps voltage ,it should be beloww 0.8 volts from memory at idle and when you look at it as a percent tps when datalogging it should be zero at idle.
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: setting Idle on the 12P code
below 0.45 at idle is normal for closed tps voltage will go into idle mode above that a bit though if its set too high it will sit there at 1000-1500 thinking its cruising along LOL
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: setting Idle on the 12P code
i have a number of no higher than 0.67v sticking in my head for some reason
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: setting Idle on the 12P code
Here is a quick log of the high idle.
- Attachments
-
- high_idle.zip
- (12.37 KiB) Downloaded 338 times
Re: setting Idle on the 12P code
Your map value seems a bit low ,there is a setting for max map for idle ,also have you set the right flags for 2 or 3 bar map sensor.
Re: setting Idle on the 12P code
Also looking at your baro ,50kpa,it should be 100.Check that the map settings match the sensor.
Re: setting Idle on the 12P code
Well my day has just turned to crap!
Have just relised that I didn't tick the 2 bar flage before I started tuning this engine, so I will have to start all over again.
Well on the bright side at least some of the issues that I have been having will start to make sense now.
Have just relised that I didn't tick the 2 bar flage before I started tuning this engine, so I will have to start all over again.
Well on the bright side at least some of the issues that I have been having will start to make sense now.
- muttley383
- Posts: 83
- Joined: Mon Aug 24, 2009 10:21 am
- cars: VR 383 stroker
Re: setting Idle on the 12P code
Just a novice question, is the idle max map setting setting " Scaler: IAC Params - Maximum MAP load limit".
I assume this setting is normally raised with aftermarket camshafts. What are the symptoms if this setting is left oem with a larger camshaft installed?
I assume this setting is normally raised with aftermarket camshafts. What are the symptoms if this setting is left oem with a larger camshaft installed?
Re: setting Idle on the 12P code
If it is set to low the manifold vac on overrun wont be enough to stop the iac from counting down while in overrun, its more of a prob with manuals,and big cams,and can cause the idle to be to low or stall when you pull up at lights.