It does effect RPM at idle as i mounted the grey wire to my HJ shifter so that in park the wire is grounded.
As i have a sloppy shifter if i move it across slightly the rpms change approx 150rpm and i notice the fueling mode window in TP dash going from open to closed loop.
Accelleration and decelleration
Re: Accelleration and decelleration
I noticed that too yesterday after I finally fixed it, no more delay before dropping to normal idle when pulling up, much nicer. Also means that it can be left in gear longer when slowing down (i.e. to lower revs) without surging.
Re: Accelleration and decelleration
is there a flag somewere i've missed to determine whether its auto or manual because when i remove that ground i can't start it but if plug it back in it thinks it an auto what have you guys done?
Cheers
Cheers
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: Accelleration and decelleration
If its an auto to manual conversion you will need to earth the start relay still. But pin B10 (P/N wire) on the ECM needs to be left open. The ECM looks at the p/n wire, if its grounded then it thinks its in Park/Neutral so assumes auto otherwise its a manual.
Re: Accelleration and decelleration
ahh righto just found out the wiring diagram i'm looking at has the ground on the wrong side of the relay sweet i'll go fix that
thanks for that
thanks for that
- vlad01
- Posts: 7796
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: Accelleration and decelleration
VL400 wrote:If its an auto to manual conversion you will need to earth the start relay still. But pin B10 (P/N wire) on the ECM needs to be left open. The ECM looks at the p/n wire, if its grounded then it thinks its in Park/Neutral so assumes auto otherwise its a manual.
is this what the factory loom section that goes under the console does when sourced from a manual car? Thats what I do.
I noticed they are wired more differently than just the P/N short that is commonly done.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.