may be a stupid question, but as im getting bored with waiting for the new trans.. Can i repin the Vr auto loom. fit the 808 with nvram and emulator, and atleast start tuning the idle and stuff while the 4l40E is still in? maybe unplugged?
or no?
cheers
vr auto PCM to Vn 808 with Emulator 12P
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: vr auto PCM to Vn 808 with Emulator 12P
i think the main difference will be the injectors are two seperate wires on the VR Auto, but you can just join them for the 808, other than that i don't see an issue
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: vr auto PCM to Vn 808 with Emulator 12P
the injectors are 2 separate wires ont he 808 too ive repinned a few, and if its only temporary, id not recommend it, it takes a few hours. just label the wires with masking tape, where it came from and where its going, then pull them all out and swap. the auto has 2 less earths than the 808 tho so you need to join in 2 more pins to create them.
Re: vr auto PCM to Vn 808 with Emulator 12P
Thanks guys appreciate the input.
I might aswell change the loom for the correct one...
Just means i have to remove the turbo again.... which is so annoying.
I guess it wasnt mean to be easy...
I might aswell change the loom for the correct one...
Just means i have to remove the turbo again.... which is so annoying.
I guess it wasnt mean to be easy...