VS-VY Enhanced Factory Bins

[The1]

you wont stop spark happening by changing the values, only where it happens. If you want spark cut, then this would have to be codded for and cal tables setup.

[hsv08]

the red column is your new gs in reference between the old v6 maf and the offset applyed to the v8 maf
I this what you were kind of wanting? the formula would be similiar id imagine

[The1]

kind of, see attached, i want the bottom 2d table interpolated to the top new one, obviously about 100 will be 0 which is fine.

table conversion.xlsx

(8.26 KiB) Downloaded 321 times

[hsv08]

kind of, see attached, i want the bottom 2d table interpolated to the top new one, obviously about 100 will be 0 which is fine.

The attachment table conversion.xlsx is no longer available

ok still not quite sure what you are wanting done.
are the white values (0.88, 0.91 etc a fixed scale)?
By interpolation i am under the assumption you want the difference of yellow and green added to yellow so you have a interpolated value between the two? ill attach but im not quite sure this is what your after. need a bit more clarification

[The1]

sorry prob need a better example, say i have 2 tables, the data is in the table with cylair upto 93-593, but i want that data into the 0-850 cylair table, so i need the values calculated and put into the new table.

[0081]

This is what i have come up with so far, not finished yet but if anyone can check if its heading in the right direction.

[slewinson]

table conversion with interpolation.xlsx

(13.23 KiB) Downloaded 322 times

sorry prob need a better example, say i have 2 tables, the data is in the table with cylair upto 93-593, but i want that data into the 0-850 cylair table, so i need the values calculated and put into the new table.

Does this make sense? some of the columns align so they are straight copies. the rest are linear interpolations.

Simon

[0081]

If i was one the right track here is my finished one

[The1]

that's correct but i can't see any calculations, youve done it manually?

[The1]

table conversion with interpolation.xlsx

sorry prob need a better example, say i have 2 tables, the data is in the table with cylair upto 93-593, but i want that data into the 0-850 cylair table, so i need the values calculated and put into the new table.

Does this make sense? some of the columns align so they are straight copies. the rest are linear interpolations.

Simon

Yeh yours is on track for what i need, should do the job, my brain hurts with all ive been doing today! So thanks!