want fuel usage to output from vt 5l ecu to vs dash
want fuel usage to output from vt 5l ecu to vs dash
Ok guys. I have just installed a vt 5l auto and ecu in my vs ute and want to get my fuel usage to display on my dash. How can I do this with changing to vs tune and loom.
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: want fuel usage to output from vt 5l ecu to vs dash
There has not been any change since you last asked the question .. http://pcmhacking.net/forums/viewtopic.php?f=7&t=3663
I doubt there ever will be a hacked VT bin when a factory VS series 3 bin works with everything in your VS, its by far the easiest option.
I doubt there ever will be a hacked VT bin when a factory VS series 3 bin works with everything in your VS, its by far the easiest option.
Re: want fuel usage to output from vt 5l ecu to vs dash
Ok. No problem.
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: want fuel usage to output from vt 5l ecu to vs dash
Actually I misread your post, read that as without swapping to the the vs loom and memcal like you asked previously.ben044 wrote:How can I do this with changing to vs tune and loom.
Don't need to swap out the loom, jus swap a few pins (compare a vs 3 and vt loom from the wiring diagram section) and run a vs series 3 memcal.
Re: want fuel usage to output from vt 5l ecu to vs dash
Are those vs tunes as good as the vt tunes.
Re: want fuel usage to output from vt 5l ecu to vs dash
The VS series III tune is essentially the same as the VT tune, it just has some different code to run VS ancilliaries, such as the fuel signal for the trip computer
Re: want fuel usage to output from vt 5l ecu to vs dash
Ok. Getting a vs s3 manual ecu and harness. Going to add auto stuff to harness